Objective

• To analyse, simulate, construct resistor circuits.

Procedure

• With an ohmmeter confirm and record the values of the supplied resistors R1, R2 and R3.
• Draw and simulate the circuit as shown. Record the values indicated in the schematic for I and V2.

Figure 1: Resistors in series

• Construct the circuit on a breadboard and measure the values indicated.
• Modify the circuit as shown above by adding resistor R3 and repeat the simulation. Record the values indicated in the schematic for I, I1, I2, I3, V1, and V2.

Figure 2: Resistors in series/ parallel

• Modify the circuit you constructed on the breadboard and measure the values indicated.

Submit your report with circuit diagram, simulated and measured results, discussion, and conclusions.