Objective:

The objectives of this experiment are:

1. To use the theory to perform relevant calculations;
2. To simulate the circuit to verify the calculations;
3. To build and test the circuit to verify the operation of the circuit.

Equipment:

Hantek 2D42 Handheld Oscilloscope (CKXXXX0071038462)

Powered breadboard (030 Genesis XX/XX)

Procedure:

1. Analyse the RLC circuit in Figure 1. Record the results of your calculations in Table 1.
2. Simulate the RLC circuit in Figure 1. Interpret the graphs and record the appropriate results in Table 1. Insert TWO graphs, one graph will display V_in, V_R, V_L and V The second graph will display V_in and I.
3. Build and perform relevant tests on the RLC circuit in Figure 1. Record the appropriate measurements in Table 1. Save a copy of the oscilloscope reading.
4. Using the simulation, change the frequency of V_in to 500Hz and 50kHz. In each case, state the effect this has on the current (I) and phase angle (𝜙). Do NOT measure the phase angle, just note if it has increased or decreased and is leading or lagging.
5. Use the lab template to write the report. Note the marks awarded in the Rubric

Results: